ANLEITUNG
 | ATTENTION:
In case of a pressure leak (e.g. on a water pipe or gas pipe) the tape should be stretched MAXIMUM, i.e. to the "LIMIT" (the point where you cannot stretch the tape further).
SPITA ResQ tape is a silicone product. SPITA ResQ tape remains flexible even after processing. This means that the material can expand when pressure is involved (so-called "ballooning"). Maximum stretching to the limit creates pressure resistance: the tape will not get any longer and will withstand the pressure.
ATTENTION: You must remove the protective liner before stretching! |
SPECIAL INSTRUCTIONS FOR USE as INSULATION TAPE:ATTENTION:
When used as insulating tape, the tape only requires stretching 10 - 50%. Stretching is only necessary to wrap the tape smoothly (without wrinkles) for optimal bonding. When used as a an alternative for a heat shrink tube (to waterproof the connector's cable entry), stretch the tape sufficiently and wrap it tightly so that moisture cannot creep under the tape.
SPITA ResQ tape is a silicone product. Even after processing, SPITA ResQ tape remains flexible. This prevents long-term damage to the cables, as the tape cannot break or become brittle (prevents against moisture penetrating the assembly).
ATTENTION: You must remove the protective liner before stretching! | 
|
TIPS:
1) SPITA ResQ-tape can be used on both sides.
2) Maximum (fast) bonding is achieved by stretching the tape and / or press
the tape down on the previous layer.
3) SPITA ResQ-tape does not have to be applied in one piece. (it usually works easier to apply multiple short pieces).
4) Repositioning is only possible within a few seconds of application.
5) SPITA ResQ-tape is not reusable.
6) A new layer can always be applied on earlier applied material
(also after many years)
7) The fusing process creates a UV resistant tape,
that can remain in place permanently.
8) SPITA ResQ-tape has a shelflife of at least 10 years when stored in the dark
at a cool place (protection against UV-rays).
|